skip to Main Content

Mask Leakage Testing System DW0570

5.0 (1 review)

DW0570 Mask Leakage Testing System is used to determine the particle protecting effect (leakage) of mask and respirator. It is suitable for medical instrument inspection center, labor protection inspection center, mask and respirator manufacturers, etc.

Category:

Mask Leakage Testing System DW0570

DW0570 Mask Leakage Testing System is used to determine the particle protecting effect (leakage) of mask and respirator.

test Principle:

Aerosol particles with certain concentration and size distribution are produced by aerosol generator. The particle concentration before and after filtering through the mask is measured by photometer; Measure the aerosol concentration inside the mask when subjects perform various movements. The particle protective effect of mask is evaluated by calculating the percentage of particle concentration reduction after aerosol passing through the mask.

Follows are features of the tester

  • The test chamber is mainly composed of main body, air purification system, exhaust duct and air sampling system, etc.;
  • The test chamber consists of glass, convenient to observe;
  • Continuous and stable aerosol particles are produced by aerosol generator;
  • Equipped with high precision photometers to ensure accurate and fast measurement of particle concentration.

Application

Application of  Mask Leakage Testing System

DW0570 Mask Leakage Testing System is used to determine the particle protecting effect (leakage) of mask and respirator. It is suitable for medical instrument inspection center, labor protection inspection center, mask and respirator manufacturers, etc.

Standards

Standards of Mask Leakage Testing System

STANDARDS BS EN 149 8.4 & 8.5 GB 2626 6.4

Note: this Dolomite Dust Clogging Test Machine can conform to but not limit to the standards above, for more standards conformance, please contact us.

Some standards might not be the full version; to read the full version for free, write an email to [email protected].
Please contact the administrator to get any violations removed.

Key specification

Key specification of Mask Leakage Testing System

Test chamber volume About 10m3
 Chamber material Glass
 Aerosol generator Salt or oil, please specify before placing order
Air flow rate No less than 100L/min
 NaCl particle Environment concentration: 4~12mg/m3

Particle size distribution: 0.02~2μm equivalent aerodynamic diameter with a mass median diameter of 0.6μm

Oil particle Environment concentration: 20~30mg/m3

Particle size distribution: 0.02~2μm equivalent aerodynamic diameter with a mass median diameter of 0.3μm

Particle sample flow 1L/min
Aerosol concentration test range 0.001~100mg/m3
Power supply AC 220V, 50Hz

1 review for Mask Leakage Testing System DW0570

  1. Kelly Herty

    All of the materials used in this product feel top-notch and high-quality.

Add a review

You may also like…

Back To Top