skip to Main Content

Draw Force Tester For Filament YG367

Rated 0 out of 5
(be the first to review)

Draw Force Tester is used for stress determination of POY filament after heating and drawing via software. It consists of control system, drive system, heating system, force measuring system.

Draw Force Tester 

Draw Force Tester is used for stress determination of POY filament after heating and drawing via software. It suit for filament testing .

Follows are Draw Force Tester For Filament specification :

  • It consists of tension controller, godet, heater, suction nozzle, temperature controller, measuring wheel, etc;
  • Computer control and test results can be printout by a printer;
  • Several test data: mean value, max. value, min. value, coefficient of variation, Q95, range, test curve of single test and heat stress distribution graph;
  • Adopt 32-bit SCM and high precision 16-bit AD converter, high speed stabilityof control system;
  • HBM load cellimported with original packaging (Germany) ;

 

Application

Application of  Draw Force Tester 

Draw Force Tester For Filament consists of control system, drive system, heating system, force measuring system. It suit for stress determination of POY filament .

It with AC servo motor and driver imported with original packaging (Japan); EMMINGER-IRO constant tension device imported with original packaging (Germany).

If you need more information about Draw Force Tester For Filament Please contact with us.

Standards

Draw Force Tester For Filament Standards  

Key specification

Key specification of Draw Force Tester 

Load range 0~500cN
Min. display value 0.01cN
Accuracy of load ≤±0.5%
Accuracy of elongation 0.01mm
Draw speed 10~400cN, adjustable
Pretension range 0.0~40.0cN
Draw ratio 60% (can be customized)
Heating temperature room temperature~300℃
Power supply AC220V, 50Hz, 800W
Dimensions 1100mm × 630mm× 1770mm

Reviews

There are no reviews yet.

Be the first to review “Draw Force Tester For Filament YG367”
Back To Top