skip to Main Content

Plastic Joint Pull-Out Resistance Tester DWLB

Rated 0 out of 5
(be the first to review)

Plastic Joint Pull-Out Resistance Tester, also named Pipe and Fittings Pull Resistance Tester which is applicable to test the tensile strength of polyethylene pressure pipe and pipe fitting at different temperatures.

Plastic Joint Pull-Out Resistance Tester DWLB

Plastic Joint Pull-Out Resistance Tester is suitable for testing the tensile strength of polyethylene pressure pipe and pipe fitting at different temperatures when subjected to longitudinal tension.

Follows are features of Plastic Joint Pull-Out Resistance Tester

  • All three independent stations can be tested, pneumatic loading, simple operation and high reliability;
  • Lever type mechanical force system, without interference between units, reliable accuracy;
  • Air bath temperature of the test chamber, the temperature is even, not overshoot, and the recovery temperature is fast;
  • Complete control temperature and timing function.
  • The integrity is good, the test box and the force device structure are compact and connected, and the structure is reasonable;
  • Bravery and outer frame in the test are made of full stainless steel material, not only beautiful and at the same time increases the corrosion resistance, and adopt double layer heat insulation glass door, convenient customer observation test, to avoid accidental burns;

Application

Application of Plastic Joint Pull-Out Resistance Tester

Plastic Joint Pull-Out Resistance Tester is used to test the creep and sealing performance of pipe fittings under constant load.

Industrial color man-machine interface +PLC distributed control structure, high reliability; The temperature range is wide enough to meet the special pipe drawing test. The test strength is reduced by the maximum reduction of electro pneumatic loading and unloading. The ball and socket joint structure, the sample loading card is convenient, adaptive force; There is no influence between station and station.

The structure of the guide sample frame is simple and reasonable, the sample installation is simple and convenient, and the balance adjustment is simple and convenient.

Plastic Joint Pull-Out Resistance Tester complies with GB/15820-1995, CJ/T175-2002 etc international and retailer standards.

If you need more information about Pipe and Fittings Pull Resistance Tester Machine. Please contact with us.

Standards

Plastic Joint Pull-Out Resistance Tester standards

GB/15820-1995 CJ/T175-2002 DIN 4271
DIN 16833 DIN 16834

 

Some standards might not be the full version; to read the full version for free, write an email to [email protected].
Please contact the administrator to get any violations removed.

Key specification

Key specification of Plastic Joint Pull-Out Resistance Tester

Test tube size range: DN16 ~ DN63.
Single-station constant load range 20N ~ 5000N.
Temperature control range: at room temperature to 95 ℃
Temperature control accuracy ±0.5.
Test station: 3
Temperature uniformity ±2
Leverage ratio: 1:10.
Creep displacement measurement range 0 ~ 100mm.
Force value accuracy ±1%.

Reviews

There are no reviews yet.

Be the first to review “Plastic Joint Pull-Out Resistance Tester DWLB”

You may also like…

Back To Top