skip to Main Content

Filter Mechanical Strength Tester DW0510

Rated 0 out of 5
(be the first to review)

Filter Mechanical Strength Tester which also named filter strength tester, It used for the mechanical strength treatment of filters.  The filter mechanical strength tester is suitable for mask and respirator production enterprises, quality supervision department and research and development institution, etc.

Category:

Filter Mechanical Strength Tester DW0510

DW0510 Filter Mechanical Strength Tester is used for the mechanical strength treatment of filters.  The tester is suitable for mask and respirator production enterprises, quality supervision department and research and development institution, etc.

Follows are features of the tester

  • The tester mainly consists of a steel case for placing filters, a steel plate, a cam and drive, control system, etc.;
  • The steel case is fixed on a vertically moving piston, capable of being lifted up 20mm by a rotating cam and dropping onto a steel plate under its own mass as the cam rotates;
  • The weight of the steel plate onto which the steel case falls is at least 10 times the weight of the steel case;
  • The filters can be placed on their sides in the steel case so that they do not touch each other during the test, allowing 6mm horizontal movement and free vertical movement.
  • Touch screen operation, easy and convenient to use;
  • Real-time display test status;
  • Adopt AC motor, the speed is accurate;
  • Adopt 32-bit ARM processor, achieves accurate control.

Application

Application of Filter Mechanical Strength Tester

Filter Mechanical Strength Tester is used for the mechanical strength treatment of filters. After subjected to the mechanical strength test, the filters can be used for subsequent performance testing such as breath resistance test or filter penetration test. The tester is suitable for mask and respirator production enterprises, quality supervision department and research and development institution, etc.

Standards

Standards of Filter Mechanical Strength Tester

STANDARDS EN 143 8.3 EN 149 8.3.3 GB 2626 6.2.2

Note: this Filter Mechanical Strength Tester can conform to but not limit to the standards above, for more standards conformance, please contact us.

Some standards might not be the full version; to read the full version for free, write an email to [email protected]
Please contact the administrator to get any violations removed.

Key specification

Key specification of Filter Mechanical Strength Tester

Drop height of steel case 20mm
Mass of steel case >10kg
Rotational frequency (100±5)r/min
Test time Approx. 20min, settable
Power supply AC 220V 50Hz
Dimension Main machine: 590×530×560mm (L×W×H)

Control cabinet: 350×350×940mm (L×W×H)

Weight 115kg

Reviews

There are no reviews yet.

Be the first to review “Filter Mechanical Strength Tester DW0510”

Your email address will not be published.

You may also like…

Back To Top