skip to Main Content

How to use Electronic single fiber strength tester?

Electronic single fiber strength tester is used to determine the breaking force and elongation at break of single textile fibers. Such as, cotton, wool, ramie, silk, glass fiber and chemical fiber. We adopt precise load cell, super subdivision stepper motor, precise ball screw and manual clamp or pneumatic clamp for your choice.

It also named single fiber strength tester or fiber tensile strength tester. FYI is one of the best fiber strength tester manufacturers and suppliers in the world, we offer good quality products with affordable price. The fiber strength tester is of special design, R&D, we provide not only good quality products, but also best after sales service.

Test procedures of electronic single fiber strength tester:

  1. Set testing parameters (Tensile speed, specimen initial length, etc.)
  2. Clamp the specimen.
  • Place the specimen in upper clamp and tighten the screw.
Place the specimen in upper clamp and tighten the screw
  • Hold the pretension clip at the lower end of the specime
Hold the pretension clip at the lower end of the specimen
  • Place the specimen in lower clamp and tighten the screw.
Place the specimen in lower clamp and tighten the screw
  1. Start test

Press the green button on the instrument to start the test and the clamp will stretch at the preset speed until the specimen breaks. At this point, the clamp will return to the initial position automatically and the test results are displayed on the interface, including the breaking force, elongation at break, elongation rate, etc. When multiple specimens are tested, instrument will automatically calculate the max, min, average value, as the figure shown.

Electronic single fiber strength tester
Specimen breaks
Specimen breaks
Interface of Electronic single fiber strength tester
Interface
  1. Print test report

Leave a Reply

Your email address will not be published.

Back To Top